full-duplex

Full duplex From Hackepedia

Full duplex means 2 channels where each channel goes in the opposite direction of the other. What this means is that at 100 Mbps full duplex you can send 100 Mbps of data and receive 100 Mbps of data for an aggregate of 200 Mbps. Collisions in full duplex cannot happen. Ethernet switches are full-duplex most of the time.

Forcing an interface into full duplex mode

In BSD you can see the media modes of an interface with the ifconfig command:
$ ifconfig -m $xl0
xl0: flags=8843 mtu 1500
       lladdr 00:60:08:5a:86:82
       media: Ethernet 100baseTX full-duplex
       status: no carrier
       supported media:
               media none
               media 10baseT
               media 10baseT mediaopt full-duplex
               media 100baseTX
               media 100baseTX mediaopt full-duplex
               media autoselect
inet 172.16.2.2 netmask 0xfffffe00 broadcast 172.16.3.255
       inet6 fe80::260:8ff:fe5a:8682%xl0 prefixlen 64 scopeid 0x2

To set it to full duplex you would type: 0:8ff:fe5a:8682%xl0 prefixlen 64 scopeid 0x2 To set it to full duplex you would type:
$ ifconfig $xl0 media 100baseTX mediaopt full-duplex
In Linux you'd use mii-tool to see the duplex setting of an interface.


German - von Hackepedia

Vollduplex heist ein doppeltgerichteter Betrieb, also 2 Kanäle, wo Kommunikation in beide richtungen zur gleichen Zeit fliesst. Das heisst das man mit 100 Mbps full-duplex kann man 100 Mbps Daten senden und 100 Mbps Daten empfangen zu einem aggregat von 200 Mbps. Kollisionen in Ethernet wie im Halb duplex modus können nicht im Voll duplex modus nicht passieren. Ethernet Switche sind meistlich Voll-duplex.

Ein Ethernet Interface zu Voll-duplex zwingen

In BSD kann man den media modus einer Ethernet Schnittstelle mit dem "ifconfig" Kommando sehen:
$ ifconfig -m $xl0
xl0: flags=8843 mtu 1500
       lladdr 00:60:08:5a:86:82
       media: Ethernet 100baseTX full-duplex
       status: no carrier
       supported media:
               media none
               media 10baseT
               media 10baseT mediaopt full-duplex
               media 100baseTX
               media 100baseTX mediaopt full-duplex
               media autoselect
inet 172.16.2.2 netmask 0xfffffe00 broadcast 172.16.3.255
       inet6 fe80::260:8ff:fe5a:8682%xl0 prefixlen 64 scopeid 0x2

Um es zu Vollduplex zu setzten würden man typpen:
$ ifconfig xl0 media 100baseTX mediaopt full-duplex
In Linux würde man das mii-tool Kommando benuzten um das duplex modii einer Ethernet Schnittstelle zu sehen.